04, 05, 06 Polaris Ranger installation instructions for HID retrofit upgrade kit.

Please note: This kit requires the use of solder less connectors to factory loom “will not” plug into factory harness.

• Remove factory Polaris bulbs, and replace with Vision X HID bulbs (put a dab of silicone on outer lip of bulb after installed)
• Mount each Vision X ballast to the left or right of the stock upper shock mount. Please note: You will be required to drill and bolt through plastic skirt (we also suggest a little silicone on back of ballast, vibration dampener)
• At this time you will need to peal the protective loom back from the Polaris loom about 4”. Cut the stock connector and bulb off, (the 4” is incase you decide to go back to stock bulbs).
• There is a Yellow/Brown and Green Polaris power wires; you will “Not” use the Yellow Polaris wire for this install. High beam not used in HID.
• At this time you will splice the Vision X Ballast to the stock Polaris wire loom.
• Splice the:
* Yellow wire at the Vision Ballast to the Polaris Green wire
*Black wire at the Vision X ballast to the Polaris Brown wire
Please duplicate for both sides (passenger and driver side)

• The yellow Polaris wire is the high beam power; you won’t have or need high beam.

Know the bulbs are in, and the Ballasts are wired to the Polaris loom, lower hood about half way closed and plug the bulbs into the ballasts.

“Note” In order to open hood completely, you will have to disconnect bulbs every time. If you activate “High Beams” the lights will shut off.