Installing 2007 Rhino conversion:

• Remove factory bulb by twisting stock bulb to the left ¼ turn while pushing inwards

• Disconnect from stock wiring harness

• Install Vision X bulb into stock headlight housing, being careful “Not” to touch glass bulb with fingers. If you do just wipe clean with a dry clean cloth.

• Install Vision X starter ballast in a place where it will stay clear or debris, use silicone on the back of the ballast to absorb some of the vibrations.

• Install supplied connectors to bulb power ends, opposite of the ballast ends (so it actually plugs in). Plug bulb wires into ballast, plug supplied wire harness into ballast and then into stock headlight wire harness.

• You’re done!

Have fun.