|
HID-336 installation instructions
• Remove factory bulb by
twisting stock bulb to the left ¼ turn while pushing inwards
• Disconnect from stock wiring harness
• Install Vision X bulb into stock headlight housing, being
careful “Not” to touch glass bulb with fingers. If you do
just wipe clean with a dry clean cloth.
• Install Vision X starter ballast in a place where it will
stay clear or debris, use supplied brackets to mount the
ballast.
• Plug each power wire (Red) from bulb to ballast and ground
(Black) to ballast using supplied hardware. Plug bulb wires
into ballast, plug supplied wire harness into ballast and
then into stock headlight wire harness for each side.
• Again this application has multiple vehicles it can fit so
please be patient and allow approximately 1-2 hrs to
install.
• Before using wire ties please start vehicle and test, if
lights don’t turn on check power leed(oval) into ballast to
make sure it’s not installed upside down (180 degrees out).
If lights flicker or blow factory fuse and then turn off,
you will need to use Vision X relay harness. If it’s not in
box please call Vision X (800) 994-4460 this is N/C. The
flicker or fuse popping can be caused by lack of power or a
tired battery, the relay harness is N/C and will fix this.
• After you get the lights to work, tie up all loose wires
and enjoy
|
HID-336.doc
HID-336.pdf
